Have a dimebucker for bridge and a generic humbucker for neck which only has a hot wire and ground. Tried sodering them in using the 1 volume 1 tone and 3 way switch using the wiring diagram on the Seymour Duncan site <http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=2h_1v_1t_3w> but when I finished I get a terrible buzz. Both pickups worked, but that buzz wont go away. Figured its a ground problem, but what did I do wrong, most importantly how can i fix it!!!!! Pictures and diagrams would be greatly appreciated.
Dimebucker for Jackson HELP!!!
- Thread starter Bonedadey
- Start date
Brandenburg
New member
Re: Dimebucker for Jackson HELP!!!
sounds like the jack is wired backwards.. 1st place id start
sounds like the jack is wired backwards.. 1st place id start
DrNewcenstein
He Did the Monster Mash
Re: Dimebucker for Jackson HELP!!!
Copper foil tape in the control and pickup cavity.
Copper foil tape in the control and pickup cavity.
treyhaislip
Well-known member
Re: Dimebucker for Jackson HELP!!!
If you do shielding make sure you do a thorough job and try to be as neat as possible...shielding that touches the wires/pots can cause issues too.
If you do shielding make sure you do a thorough job and try to be as neat as possible...shielding that touches the wires/pots can cause issues too.
Similar threads
