Everything Axe Wiring Plus Blender Pot Question

[Bonovetters]

I am rewiring the everything axe setup in a strat with the 5-way super switch and wanted to just have 1 master tone pot and a no load blender pot in the second tone spot to blend the neck into the 1 and 2 position spots. I know I need to wire the master tone into the volume pot and not the 5-way as you would for it to be used just on the neck but can anyone help me with where I need to wire the blender pot in on the 5-way super switch? I have scoured all over trying to find this but can only find either this setup with the standard 5-way or the super switch wired up but with standard single coils.

The closest I can find is this SD wiring diagram for the everything axe but with the two tone pots.

zz0.9epv15tzh9azz

Thank you

 

[Artie]

This diagram from Lindy Fralin is one of the best I've seen.

 

[Bonovetters]

Thank you for your reply. I think this is all I have to do but wasn’t sure if someone with better knowledge than I have could verify. I can always set it up and keep testing it out I suppose but wish I could get a definite thumbs up or down.