I'm actually amazed at how simple that diagram is. Yeah you'd be able to do this diagram but remember to watch out with the black and white wires switching. Be sure you get the right kind of super 5 way switch as some go 0-12345-12345-0 and others are opposite for the positions. 0-54321-54321-0. Both are doable for this diagram.
Now I do remember that PRS set had some sort of hum cancellation in the center with coilsplits. This is when the pick measures can swoop in and tell me as I haven't played PRS guitars with that model of pickups in it. That is my only concern converting to a seymour duncan diagram as the person who drew it out left bits and pieces out. I was like what the heck is this with the switch going 1-4 on one end and only two commons
On one hand it's not 10 radically different sounds.. on the other this is an easy to install wiring.
Here is so far. Just need assurance how the bridge pickup goes in. But some arm chair hero I suppose can swoop in and jazz this up in microsoft paint. You can add the treble bleed too but if you haven't got the 500k push pull yet I'd seriously just go B500k. That's my own 2 cents though.
I hooked up the resistor in a way that there is less risk the resistor will break as I hated how it was "dangling". That sounds wrong but on short notice it had to be done to the 1.1k (1k1) resistor. I'd say go carbon 1/4w if you've got to source the resistors from Tayda2009 if we can even get stuff from Thailand right now because of what's going on with the corona virus.
View attachment 103180
