George Lynch Kamikaze Wiring Issue

[iYOAK556]

So I’m wiring a project with a George Lynch Kamikaze setup, one push/push pot to control volume and pickup selection. It’s wired as per the diagrams I can find, however my bridge pickup(SD Jupiter) is split and is now essentially a single coil. That is not the intended result. I don’t have a picture of mine right now but it’s wired just like the attached picture.

What would be causing the bridge to coil split if wired in this configuration?

 

[Mincer]

Welcome to the forum!

If the series link wires were not connected to each other (red & white in Duncan pickups), it can cause this. Also, a bad coil. What are the other wires doing on the Jupiter?

 

[iYOAK556]

Welcome to the forum!

If the series link wires were not connected to each other (red & white in Duncan pickups), it can cause this. Also, a bad coil. What are the other wires doing on the Jupiter?

Standard SD wires. Red/white soldered together, green/bare to the ground and black to the top lug like in the photo. It’s possible the red/white came unsoldered under the heat shrink I have on them but that’s unlikely. Worth checking again I suppose.

 

[Mincer]

Measure the DCR of the pickup, too to confirm both coils are working (and it isn't the switch).

 

[jeremy]

if its switching between neck and bridge fine, i doubt its the switch. like dave said, check the dcr