Getting them back in phase

[MarkRocks]

I just got a new Saturday Night Special bridge for my '17 LP Tribute. A great upgrade from the Gibson 490T that came with the guitar.

I have it set up with push-pull pots on the tone controls to split the coils.

When I followed the standard instructions for wiring the new pickup, it ended up putting the pickups out of phase.

So here's my question... If I want to reverse the phase of my SD pickup. how do I wire it?

Right now, it's set up as instructed on the SD wiring diagram:

Black to one lug on volume pot
Red and white to middle lug on push-pull
Green and ground to ground

So if I wanted to reverse the phasing of this pickup, would I just switch the black and green? Or is there a different way to do this?

Thanks!

 

[AlexR]

Re: Getting them back in phase

Switching the black and green will do it......note - it will also switch the coil that you split to (from slug to screw). I am not quite sure if this will make the split selection OOP as a result.....you might need some better heads on the case on that one.

 

[Mincer]

Re: Getting them back in phase

Also, the bare wire still goes to ground.