Help: Tele wiring 2 H, 2 Vol, etc.

[torgeot]

OK I've been looking over the wiring schemes, haven't found this one yet.

Full humbucker in the neck
Rail in the bridge

I have a push/pull 500 k pot for the Rail that I want to be able to split but I don't need to split the neck, so that has a regular 500K pot

so 2 hums (1 splitable), 2 volumes (no tone) tele switch (3 way - Neck, both, bridge)

I've still looking for a diagram for this, or someone that has done it. I can probably figure it out eventually but if someone has done it or has seen a diag for it let me know.

Thanks!

 

[jeremy]

Re: Help: Tele wiring 2 H, 2 Vol, etc.

welcome to the forum!

if you take this diagram:

http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=tele_2v_no_tone

and look at this to split the coil you should be fine

http://www.seymourduncan.com/suppor...matics.php?schematic=tele_1hum_1sing_pushpull

 

[torgeot]

Re: Help: Tele wiring 2 H, 2 Vol, etc.

In the 2 vol no tone diagram, I see that they suggest going from tip right up to the switch I get a little confused as what to do with the bridge volume pot at that point. I was thinking green&bare to ground, and one leg of the pot, red & white to a middle leg on the push/pull, ground to the lower push/pull, but here's where I get confused, should the black go up to the lever switch and what do I do with the other 2 lugs on the vol pot?

 

[torgeot]

Re: Help: Tele wiring 2 H, 2 Vol, etc.

something like this maybe?

I kind of took some thoughts and copied pasted a few things

 

[torgeot]

Re: Help: Tele wiring 2 H, 2 Vol, etc.

ahh, I got it, this was close, I will post an update to this for anyone who may want to use it. the issue in in the switch will update the pic and post within a day or so.

 

[torgeot]

Re: Help: Tele wiring 2 H, 2 Vol, etc.

OK the diagram above has been updated, it is now correct.