Help with fender S-1 switch

[Gerryblue]

Hey

I'm not that good when it comes to wiring, (can solder though) I want to wire my 3 Hot Rails to one Fender S1 switch volume pot, to make it so that when pushrd, it splits all coils, and when in regular position, I get full humbucking sound.

Does anyone have a diagram they can share? My PU selector switch is a regular 5 way, and I dont want any other mod, just coil splitting.

Thanks!

 

[Will S-T]

Re: Help with fender S-1 switch

Here's a link to a pic of the underside of the switch

http://www.jbepickups.com/wp-content/uploads/2013/12/S1-bottom-view.jpg

It has 4 poles so you can use one for each of the three pickups.
You solder the red and white wires to the A lug and the black to
the C lug. A new wire from the B lug then becomes the output for
that pickup and is wired to the selector switch. Grounds are wired as normal.

Cheers

 

[Gerryblue]

Re: Help with fender S-1 switch

Thanks, you're a life saver! Is the green one ground also? Should I join them to the bare wire? Thanks again

 

[Will S-T]

Re: Help with fender S-1 switch

Thanks, you're a life saver! Is the green one ground also? Should I join them to the bare wire? Thanks again

Yep, as per this diagram

http://www.seymourduncan.com/wp-content/uploads/2015/05/EAX_1V_2T.jpg

 

[Gerryblue]

Re: Help with fender S-1 switch

Thanks again kind sir, cheers!

 

[Will S-T]

Re: Help with fender S-1 switch

Enjoy mate!