Help with wiring HH in an ibanez

[gita]

Well i have never posted on any forums but here i am! Im wondering is there a way to wire up 2 humbuckers on a 5 way switch like this:
1: Bridge
2: Bridge South
3: Neck+Bridge
4: Neck North
5: Neck
and then im wondering if i added a push pull pot if i could do something like this: (when pulled up)
1: Bridge North
2: Bridge North+Neck North
3: Bridge South+Neck North
4: Neck South+Bridge South
5: Neck South
im wondering what i would need to do this and all i can come up with so far is a super switch and a push pull pot so before i even attempt to buy those things im wondering if theres a diagram for this and if its possible
oh being ibanez its one volume one tone
help would be greatly apreciated!

 

[gita]

just to clarify im not fully set on that combination of things and im totally open to any suggestions im just trying to get the most out of my cheapo axe (150$ ibanez gio) the pickups in them are iffy sounding (the bridge sounds freaking awesome but the neck is wayy too muddy) so im just upgrading them entirely and probably gonna use the bridge in one of my project guitars

 

[Artie]

Welcome to the forum. A Superswitch would definitely do the first part. I'll have to study it closer to see about the 2nd part. But could you substitute "stud" and "screw" for north & south? Not all pups have the same magnetic polarity, so those terms can be a bit ambiguous.

 

[gita]

Welcome to the forum. A Superswitch would definitely do the first part. I'll have to study it closer to see about the 2nd part. But could you substitute "stud" and "screw" for north & south? Not all pups have the same magnetic polarity, so those terms can be a bit ambiguous.

yes my bad im gonna be installing pafs so not sure what to call the part where its just flat metal but ima assume thats the studs so pretty much anything that says north on the neck is screws and anything that says south on the bridge is screws