HH toneless wiring help

[LeeT4321]

Help me find a diagram for dual humbucker, 2 volumes, 0 tones...500k pots

it's my Squier Super-Sonic. Finally got my SH 2N to match the SH4!!!

Hot rod VROOM VROOM :14:

Right now, I've got the trem wire hanging loose...no idea where to solder it to.

I also did the messiest job ever. For some reason, after installing just a neck pickup, my bridge pup has gone fuzzy. It's also fuzzy when I switch channels via toggle. I hope I didn't A. bump a wire with the soldering iron or B. accidentally pull a wire loose from the toggle switch.

 

[Funkfingers]

Re: HH toneless wiring help

http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=2h_2v_3w

The vibrato claw ground wire goes to the chassis of one of the pots.

 

[LeeT4321]

Re: HH toneless wiring help

thanks. but where should I solder the green bridgebucker wire to? side or top of bridge pot? Or does it not matter?

 

[AlexR]

Re: HH toneless wiring help

All pot casings are ground, whether its the top, side etc. If you feel one of the pots has too many grounds attached then solder it to the other - they'll be a connector b/w the two anyhow.