High output pickups have low output in Gibson SG

[cokekolev]

Re: High output pickups have low output in Gibson SG

That sounds like primary side of pots, you disconnected, where pups go.

Did you disconnect where output jack hot was connected?
It goes to wiper of volume pot, which still has connection to ground.

Flipping guitar over could easily move volume control, I mean, making maybe very much load on pickup to ground sounding weak - for this test that is.

The test was to secure that pickup was ok, or?

If volume is at 10, probably ok, but just mention a possible cause test fails.

With wiper at 10, there is 500k to ground, and ok.
With wiper just above 1, it could be 1k or less to ground, strangling pup.

I did NOT use the guitar output. I took the pickup wires and connected them directly to the guitar cable, without using any of the guitar's electronics.

 

[TimH89]

Re: High output pickups have low output in Gibson SG



I did NOT use the guitar output. I took the pickup wires and connected them directly to the guitar cable, without using any of the guitar's electronics.

Did you ever find the problem about the guitar? I have a Gibson SG with the same issue.

 

[jeremy]

i expect the issue was with the covers. the pups dc resistances are correct for series wiring and since he wired it directly to a cable and it still had the issue, thats the most likely suspect.

might be better to start your own thread with all your details so we can figure it out

 

[cokekolev]

Did you ever find the problem about the guitar? I have a Gibson SG with the same issue.

No, I didn't and had forgotten about it. Yesterday I put covers on a Les Paul, so today I'll check if the pickups (Custom+Jazz) sound any different.

 

[JB_From_Hell]

Since no one else has said it... take off the covers and see what happens.

 

[playas]

Assuming you have played with the pickup heights and as you've commented on your familiarity with pickup changes, why don't you put one of the pickups from your LP in the SG for comparison to give you a clear idea where the issue resides?

Then you can go from there having a better idea if the pickups themselves are the source of the problem.

 

[Condemned soul]

+1 for the pickup covers.
Due to past experiences, I can say this. Some aftermarket covers will sit higher over the pickup coils which in turn increases the distance from the strings.