I want to set up my Schecter with 2 humbuckers, 1 volume, 1 tone and a 3 way switch. I'd like to put a push/pull on the tone control for a coil tap to split each humbucker to single coil. I'm a little confused on which schematic to follow in the wiring diagram setup. Can anyone advise. Thanks.
Humbucker Wiring Question
- Thread starter MrWolf
- Start date
Artie
Peaveyologist
Re: Humbucker Wiring Question
Hi MrWolf; Welcome to the forum.
Use this diagram with a couple of simple "mods".
http://www.seymourduncan.com/website/support/schematics/2hum_vol_tone_3way-w-split.html
I would connect the "ground" to the top lug, instead of the bottom lug, so the coils are split when you "pull" the knob.
Also, duplicate the red/white wires for the other pickup on the "mirror" side of the switch. That is, the opposite side, exactly like the other side. That will split both pups.
If you're still not sure, let me know. I'll make you a custom diagram.
Artie
Hi MrWolf; Welcome to the forum.
Use this diagram with a couple of simple "mods".
http://www.seymourduncan.com/website/support/schematics/2hum_vol_tone_3way-w-split.html
I would connect the "ground" to the top lug, instead of the bottom lug, so the coils are split when you "pull" the knob.
Also, duplicate the red/white wires for the other pickup on the "mirror" side of the switch. That is, the opposite side, exactly like the other side. That will split both pups.
If you're still not sure, let me know. I'll make you a custom diagram.
Artie
Similar threads
