Hyper Switch wiring help

[Profretguy]

Hello all,

I am trying to wire up my guitar with a hyper switch but am a bit confused at the moment. does anyone have a diagram or can help me?

i am running Prails in the neck and bridge and vintage rail in the middle with 1 volume and 1 tone.

any help would be greatly appreciated.

Cheers,
Steve

 

[RevDoom73]

You might already have this at your disposal but just in case, here's a link to the Hyperswitch Install Guide: https://www.seymourduncan.com/wp-content/uploads/2023/04/HS-Install-Guide-v3.pdf

There's a general page/directory for the Hyperswitch that has a bunch of helpful links- https://www.seymourduncan.com/hyperswitch-support

I've not installed a Hyperswitch myself so honestly I don't think I could help you much with that, but I wouldn't hesitate to contact Duncan's support directly to have them walk you through what you need to do to wire up the P-Rails and Vintage Rails. They're always really good about helping out with these kinds of issues:

support@seymourduncan.com
Tech Support Hotline: (805) 716-6747

 

[beaubrummels]

Vintage Rails are designed to be wired in parallel, but they are 4-conductor so you can wire them 'normally'. To wire in parallel, you put black+red to hot and green+white+bare to ground.

Other than that, what specifically are you confused about?