I need wiring help!!

G

geezzzer

New member
Hi all! I decided picked up a Seymour Duncan Liborater 500K pot and have a question.... The wiring diagrams on the seymour site show a wire that reads "ground from bridge". What is this? I am trying to wire up a lone humbucker to the liberator. The body i am putting them in had no electronics in it before.
Please help!
Geezzzer...
 
Re: I need wiring help!!

Post the Diagram. Just what it says. Ground wire from bridge. All bridges are grounded.

- - - Updated - - -

Actually I've got a Epi SG Jr that didn't have one so I put a wire under the bassE at the back of the bridge & solder it to the base of the bridge P-90. Killed the junk Hum sound....
 
Re: I need wiring help!!

I should have also mentioned that the bridge is a floyd rose....not sure where to run the ground...:banghead:
 
Re: I need wiring help!!

Take a volt meter set at ohms and check continuity to ground







I've got two Floyd Rose bridge guitar. I'll look at them & get back as to where they're grounded.....
 
Re: I need wiring help!!

Each electric guitar has a ground wire to ground the strings via the bridge and electronics. Thats the wire that the liberator needs. It is synchronous with the wire on the back of the pot.
 
You must log in or register to reply here.
Back
Top