Zombie 13X33
New member
Sorry for the picture quality but the pictures of the lights on were taken in the dark to show them off better.
Removed the pickguard and cut out a spot right under the smaller radiation sticker for a 2 aa battery holder and then drilled out small cavities in the corners where the humbuckers are. Then ran 8 5mm leds with 10 ohm resistors on each light. I used the middle pickup cavity to hold the wire for all the resistors. Everything is soldered and shrink tubed and the lights are held in with hot glue so I can remove them or replace them if needed. Was a little nerve racking when I took out the dewalt multi tool and cut out the cavity for the batteries but it all worked out good. I think. The lights are silly but it's just always been my thing to try to squeeze lights into anything and everything I can. Let me know what you folks think!
Removed the pickguard and cut out a spot right under the smaller radiation sticker for a 2 aa battery holder and then drilled out small cavities in the corners where the humbuckers are. Then ran 8 5mm leds with 10 ohm resistors on each light. I used the middle pickup cavity to hold the wire for all the resistors. Everything is soldered and shrink tubed and the lights are held in with hot glue so I can remove them or replace them if needed. Was a little nerve racking when I took out the dewalt multi tool and cut out the cavity for the batteries but it all worked out good. I think. The lights are silly but it's just always been my thing to try to squeeze lights into anything and everything I can. Let me know what you folks think!