JOLLY
Super Simonologist
I just spread out each of my Marshall 1960 cabinets about 10 feet apart in my living room. They're on each side of the TV. I'm going to set my rack which consists of my Eleven Rack and a Gem Sound XPS 1000 on the living room table, and hope that I sound great.
Now, what I need to know before I do this is about hooking it up.....I think. I'm pretty sure I know how, but I just want to check to make sure.
This is the back of the power amp:
View attachment 39118
and this is the back of the Eleven rack:
View attachment 39119
Now, I have all of the speaker cables and everything that I think. I'm thinking that I'm going to run from the main output left (mic cable) of the Eleven rack into the input of the Channel A (mic cable) of the power amp. Also run the main output right (mic cable) of the Eleven Rack into Channel B (mic cable) of the power amp. From there I run my Speakon cables from the Power amp into each Marshall 4x12 sepaerately. hopefully this all makes sense.
I will be setting each of my 4x12 cabinets at 4 ohms and running them in stereo. Or should I run them at 8 ohms in stereo? I'm thinking that either 4 ohms or 8 ohms will be fine. It's not like I'm going to be playing it 11 billion dB or anything.
What do you think? Am I going to do it correct? Thanks in advance!!
Here's the specs on the power amp:
Now, what I need to know before I do this is about hooking it up.....I think. I'm pretty sure I know how, but I just want to check to make sure.
This is the back of the power amp:
View attachment 39118
and this is the back of the Eleven rack:
View attachment 39119
Now, I have all of the speaker cables and everything that I think. I'm thinking that I'm going to run from the main output left (mic cable) of the Eleven rack into the input of the Channel A (mic cable) of the power amp. Also run the main output right (mic cable) of the Eleven Rack into Channel B (mic cable) of the power amp. From there I run my Speakon cables from the Power amp into each Marshall 4x12 sepaerately. hopefully this all makes sense.
I will be setting each of my 4x12 cabinets at 4 ohms and running them in stereo. Or should I run them at 8 ohms in stereo? I'm thinking that either 4 ohms or 8 ohms will be fine. It's not like I'm going to be playing it 11 billion dB or anything.
What do you think? Am I going to do it correct? Thanks in advance!!
Here's the specs on the power amp:
- 750W RMS @ 8 ohm bridged mono
- 375W per channel RMS @ 4 ohm
- 250W per channel RMS @ 8 ohm
- Left-Right level controls
- Parallel stereo bridged
- Ground lift
- Inputs: 1/4" and balanced XLR
- Protect LED, Peak LED
- Fan cooled
- Rack mountable 19"W x 3.5"H x 14"D
- 115V/230V switchable
- 35-1/5lb.