Is an attenuator an electrical load?

[VinceT]

Just a quick note on the THD hotplate, in the LOAD setting (silent) it provides enough impedance for the output transformer’s signal (8 Ohms for the purple model, 16 Ohms for the blue), but ANY of the other settings requires a speaker to be connected to provide the load.


Sent from my iPad using Tapatalk

 

[PFDarkside]

It's hard to describe. It's served warm and the potatoes are sliced rather than diced. And I think you're right about it being vinegar based, and it has bacon. You almost have to look up the recipe. There's one that comes in a can that's ok, when you don't have a good German restaurant around.

Gotcha. My grandma made something similar, that’s why I ask. Hers was a little more simple.

 

[JMP/HBE]

Just a quick note on the THD hotplate, in the LOAD setting (silent) it provides enough impedance for the output transformer’s signal (8 Ohms for the purple model, 16 Ohms for the blue), but ANY of the other settings requires a speaker to be connected to provide the load.


Sent from my iPad using Tapatalk

Yes correct. Comes in very handy biasing my amps so i don't have to drag a cab around.

Plus the Hot Plate has a line out.

 

[VinceT]

Yes correct. Comes in very handy biasing my amps so i don't have to drag a cab around.

Plus the Hot Plate has a line out.

I use the line out of my Hotplate for silent recording all the time - into Redwirez IRs, works like a charm!


Sent from my iPad using Tapatalk