Is this BMP and TS wiring diagram correct?

[Oropher]

Hi all. A few weeks ago I saw that two new awesome products were released from Seymour Duncan, the Triple Shot mounting ring and the Blackout Modular Preamp. I also saw the the video with Frank talking about the 4PDT switch. Then I knew I just had to make a guitar with both. Since I'm not really good with wiring, I have a question. I made a concept wiring diagram, so my question is, is this correct? I just sort of combined some wiring diagrams and I'm also not that good with MS paint, so it's a bit of a mess, but anyway.

I attached the diagram if all went well.nder:

 

[Oropher]

Re: Is this BMP and TS wiring diagram correct?

nobody?

 

[metalmachine]

Re: Is this BMP and TS wiring diagram correct?

wow

 

[mustaine-who?]

Re: Is this BMP and TS wiring diagram correct?

I think if you tried...you could make it even more complicated for even more diminishing rewards...

 

[Oropher]

Re: Is this BMP and TS wiring diagram correct?

I think I have to explain it a bit better, I don't need advice whether or not I'll make this beast, just advice on it's correctness. The lone middle humbucker at the right is a hot rails neck, btw. So, if I drew it right, the push/pull knob will switch neck/bridge humbucker in BMP mode, and the 5-way will look like this:

1 Neck
2 Neck + Middle
3 Middle
4 Bridge + Middle
5 Bridge

Is this assumption correct? Also, will my guitar explode (or something similarly nasty) when I switch one of the 4PDT switches, but leave the other in 'passive mode'?

And please, I need constructive advice