Jack_TriPpEr
Well-known member
I am about to work with P-Rails for the first time, installing a set into a LP type guitar.
I would like to use the SD wiring diagram hosted here on the SD website (pic below) that uses 2 push pull pots to do the coil-splitting etc. work, but am wondering if the errors that were reported in this thread were ever corrected? There is reply in that thread from veteran forum member ArtieToo that confirms the error plus Artie identifies another SD-designed diagram for P-Rails that has another error.
Also, are the push-pulls in this diagram depicted upside down, so that left is right and up is down?
Thanks

I would like to use the SD wiring diagram hosted here on the SD website (pic below) that uses 2 push pull pots to do the coil-splitting etc. work, but am wondering if the errors that were reported in this thread were ever corrected? There is reply in that thread from veteran forum member ArtieToo that confirms the error plus Artie identifies another SD-designed diagram for P-Rails that has another error.
Also, are the push-pulls in this diagram depicted upside down, so that left is right and up is down?
Thanks

