Is this SD wiring diagram for P-Rails error-free?

Jack_TriPpEr

Well-known member
I am about to work with P-Rails for the first time, installing a set into a LP type guitar.

I would like to use the SD wiring diagram hosted here on the SD website (pic below) that uses 2 push pull pots to do the coil-splitting etc. work, but am wondering if the errors that were reported in this thread were ever corrected? There is reply in that thread from veteran forum member ArtieToo that confirms the error plus Artie identifies another SD-designed diagram for P-Rails that has another error.

Also, are the push-pulls in this diagram depicted upside down, so that left is right and up is down?

Thanks

2PRail_3G_2V_2TppSPL.jpg
 
Re: Is this SD wiring diagram for P-Rails error-free?

The diagram appears to be correct.

Keep in mind that when you are looking at a wiring diagram such as this, the "top" of the p/p is the part attached to the back/bottom of the pot, and the top of the pot is the shaft, the part where the knob is attached which is facing away from you.
 
Re: Is this SD wiring diagram for P-Rails error-free?

The diagram appears to be correct.

Keep in mind that when you are looking at a wiring diagram such as this, the "top" of the p/p is the part attached to the back/bottom of the pot, and the top of the pot is the shaft, the part where the knob is attached which is facing away from you.

So the section i circled in blue below, represents the push-pull switch in the "down/push" position, correct?

20190211_181927.jpg
 
Re: Is this SD wiring diagram for P-Rails error-free?

I have used this schematic often. No issues.
 
Back
Top