LCR network
- Thread starter walters
- Start date
- Status
G
Guest
Guest
Re: LCR network
To know the LCR value you need to get laid.
To know what a magnet is you need to lay off the drugs and sauce.
For a magnet to have a frequency response you need to seek medical help.
To get different frequencies from diffrenet magnets you need to be 100 years old, rich, listen to 50c and be gay.
Having said all that I make Zerbs words mine. FAQ off!
To know the LCR value you need to get laid.
To know what a magnet is you need to lay off the drugs and sauce.
For a magnet to have a frequency response you need to seek medical help.
To get different frequencies from diffrenet magnets you need to be 100 years old, rich, listen to 50c and be gay.
Having said all that I make Zerbs words mine. FAQ off!
G
Guest
Guest
Re: LCR network
Wait a minute, maybe this guy should stick around. Its fun to screw with him.
Wait a minute, maybe this guy should stick around. Its fun to screw with him.
stevie_bees
Cat In The Hatministrator
Re: LCR network
Must be female because of the size of the udders. It helps if they're mad cows too!!Zerberus said:
G
Guest
Guest
Re: LCR network
ROTFLMFAO
walters said:
ROTFLMFAO
G
Guest
Guest
Re: LCR network
Nope. Wi be stoopid.
Nope. Wi be stoopid.
Zerberus
Baron Von Shred
Re: LCR network
Dude, you´re talking out your ass so loud I can´t hear your farts... This is my last even semi-serious post in this thread ... you don´t care for knowledge, you make that very obvious, you care only for stirring up ****...
But that you´re admittedly not half bad at. I bet your braces can´t wait for the first high-school bully to punch them through the back of your skull... please send me a pic when it happens.
Fact: A1-9 and "Ceramic" mags used in pickups are VERY permanent... Were they not permanent, no pickup would work without an Generator or battery. They can be gaussed to different strengths, but once magnetized will hold that charge for years after you die trying to tell them to "go out". As further proof: we can remove them, replace them, and the whole time they´re, get this, STILL MAGNETIC!!....
OH MY GOD!!! I´ve just discovered a permanent electromagnet that needs no electricity, where´s my Nobel Prize?:laugh2:
Fact: Wire does NOT produce a magnetic field. That´s what the magnet is for.
Pickups work becasue of a magneticall responsive material oscillating in the flux field created by the magnet and directed by the poles... the oscillation causes changes/ fluctuations in the field, these changes are picked up by the coil, and by principle of induction turned into electric current.
You have no idea what you´re talking about, just really too bad that you don´t want an idea, either...
Anyone have an african swallow and a coconut??
walters said:
Dude, you´re talking out your ass so loud I can´t hear your farts... This is my last even semi-serious post in this thread ... you don´t care for knowledge, you make that very obvious, you care only for stirring up ****...
But that you´re admittedly not half bad at. I bet your braces can´t wait for the first high-school bully to punch them through the back of your skull... please send me a pic when it happens.
Fact: A1-9 and "Ceramic" mags used in pickups are VERY permanent... Were they not permanent, no pickup would work without an Generator or battery. They can be gaussed to different strengths, but once magnetized will hold that charge for years after you die trying to tell them to "go out". As further proof: we can remove them, replace them, and the whole time they´re, get this, STILL MAGNETIC!!....
OH MY GOD!!! I´ve just discovered a permanent electromagnet that needs no electricity, where´s my Nobel Prize?:laugh2:
Fact: Wire does NOT produce a magnetic field. That´s what the magnet is for.
Pickups work becasue of a magneticall responsive material oscillating in the flux field created by the magnet and directed by the poles... the oscillation causes changes/ fluctuations in the field, these changes are picked up by the coil, and by principle of induction turned into electric current.
You have no idea what you´re talking about, just really too bad that you don´t want an idea, either...
Anyone have an african swallow and a coconut??
Last edited:
stevie_bees
Cat In The Hatministrator
Re: LCR network
I want to order 1 of the pickups you build, walters, cos they're gonna be unique!!
I want to order 1 of the pickups you build, walters, cos they're gonna be unique!!
Artie
Peaveyologist
Re: LCR network
Actually, a pickup, and any coil for that matter, does have LCR. LCR stands for Impedance/Capacitance/Resistance. They use L for impedance for the same reason circuit diagrams use Q for transistors - "T" had already been taken for "transformers", and "I" had already been taken for "current", (aka, induction).
The LCR of a pickup is determined by the wire guage, number of turns, spacing, (as in tightness of the wind), and the proximity and makeup of metal in the pickup. You can't, as a practical matter, change any of these except for placing, or removing, metal from the pickup. Thats the basis for the Twangbanger and Fralin bridge plate.
You can affect the inductance and capacitance by wiring an inductor, (ala Bill Lawrence Q-filter), or capacitance, (my own de-mud mod), into the wiring of the pickup. Other than that, you're limited to what you can do.
Hope this helps.
Artie
Actually, a pickup, and any coil for that matter, does have LCR. LCR stands for Impedance/Capacitance/Resistance. They use L for impedance for the same reason circuit diagrams use Q for transistors - "T" had already been taken for "transformers", and "I" had already been taken for "current", (aka, induction).
The LCR of a pickup is determined by the wire guage, number of turns, spacing, (as in tightness of the wind), and the proximity and makeup of metal in the pickup. You can't, as a practical matter, change any of these except for placing, or removing, metal from the pickup. Thats the basis for the Twangbanger and Fralin bridge plate.
You can affect the inductance and capacitance by wiring an inductor, (ala Bill Lawrence Q-filter), or capacitance, (my own de-mud mod), into the wiring of the pickup. Other than that, you're limited to what you can do.
Hope this helps.
Artie
stevie_bees
Cat In The Hatministrator
Re: LCR network
Shouldn't that be Inductance/Capacitance/Resistance?
Shouldn't that be Inductance/Capacitance/Resistance?
G
Guest
Guest
Re: LCR network
Hey walters, can you get me a X-shaped pup?
stevie_bees said:
Hey walters, can you get me a X-shaped pup?
Re: LCR network
How do i set the Attack and Compression of a Pickup?
Whats the compression of a pickup?
A1-9 and "Ceramic" mags They can be gaussed to different strengths, but once magnetized will hold that charge for years after you die trying to tell them to "go out"
Yes different Gaussed is different strengths but also different frequency responses but a A2 has midrange peaks so how do u put a FACT to that a A2 have midrange?
The magnetizing and strength has nothing to do with the mixture of how a A2 has midrange peaks
Can u explain why a A2 has midrange peaks or midrange frequencys?
Fact: Wire does NOT produce a magnetic field. That´s what the magnet is for.
Then what is the Wire used for then? why would wire turns matter?
How do i set the Attack and Compression of a Pickup?
Whats the compression of a pickup?
A1-9 and "Ceramic" mags They can be gaussed to different strengths, but once magnetized will hold that charge for years after you die trying to tell them to "go out"
Yes different Gaussed is different strengths but also different frequency responses but a A2 has midrange peaks so how do u put a FACT to that a A2 have midrange?
The magnetizing and strength has nothing to do with the mixture of how a A2 has midrange peaks
Can u explain why a A2 has midrange peaks or midrange frequencys?
Fact: Wire does NOT produce a magnetic field. That´s what the magnet is for.
Then what is the Wire used for then? why would wire turns matter?
stevie_bees
Cat In The Hatministrator
Re: LCR network
I think I'm going to use it to hang myself.
walters said:
I think I'm going to use it to hang myself.
stevie_bees
Cat In The Hatministrator
Re: LCR network
I'm just pleased I remembered something from my electronics trade training! It's been a while and due to computers, the basics just don't get used any more!
ArtieToo said:Yes. You are correct. I was typing fast and talking out my . . . well, you know.
I'm just pleased I remembered something from my electronics trade training! It's been a while and due to computers, the basics just don't get used any more!
G
Guest
Guest
Re: LCR network
If only he'd use it himself... the wire... you know, to hang himself... OH NO, could this be understood as a threat? LOL
If only he'd use it himself... the wire... you know, to hang himself... OH NO, could this be understood as a threat? LOL
- Status
Similar threads
