Liberator /Triple Shot Troubles.

bzrkrage

bzrkrage

New member
Morning all!

Newb, bought the Liberator, Neck p-rail (w/Tripe Shot)((not working BTW))
& Pearly Gates in the bridge of my PRS SE Single cut.
Wired it all away, (Thanks for the video's, very good).

How does the triple shot wiring go into the Liberator (B/W/Bare into?????)

and why does the Liberator only adjust at the last of the turn for volume. (The PG works, that is all.)

Cheers gang, hope you can help.

(Post pics if needed)
 
Re: Liberator /Triple Shot Troubles.

The triple shot has a Hot and a Neutral + a bare wire ground. So replace a SD pickup wiring on Liberator to (pickup Black) hot for Triple Shot and (pickup Green) for Triple Shot Neutral.

There will be no Red and White on the Triple Shot, so leave those empty on the Liberator. The Bare Wire will go to back of Board to one of the GND spots or tie in with other grounds elsewhere.
 
Re: Liberator /Triple Shot Troubles.

Actually the Liberator has a slot for the bare wire as well, and its already connected internally to ground. It leads to a grey wire which can be used to solder ground to the other potentiometers.

As for the pot only working at the end of the travel, I don't know what to tell you. Could be something with the wiring, the pot could be defective, or something else even.
 
Re: Liberator /Triple Shot Troubles.

Thank you! P-rail & triples hot working well. Now have to talk to SD about the Liberator, she may have to go back.


Sent from my iPhone using Tapatalk - All Round Nice Guy.
 
You must log in or register to reply here.
Back
Top