darthphineas
New member
this is the licensed Floyd off my Kramer Pacer Classic. upgraded to a real Floyd. this one is less than 6 months old, so it is used/pre-owned/etc. this could be considered to be on par with the FR Special or with any typical licensed FR. good for a partscaster, that project you're working on, or as a backup.
what you see is what you get - trem and arm. the sustain block would fall into the 37mm bracket, although it is technically 35.5mm. I have 32mm OFR blocks sitting around and can swap it if you need that size... sorry, no 42mm on hand right now.
$60 shipped in conUS via PayPal (gift preferred).
note: just noticed the saddle screw on the high E saddle is different. :eyecrazy: probably from grabbing in to the pile of saddle screws on the work bench. it will be replaced with the one that goes with it right after I post this.
what you see is what you get - trem and arm. the sustain block would fall into the 37mm bracket, although it is technically 35.5mm. I have 32mm OFR blocks sitting around and can swap it if you need that size... sorry, no 42mm on hand right now.
$60 shipped in conUS via PayPal (gift preferred).
note: just noticed the saddle screw on the high E saddle is different. :eyecrazy: probably from grabbing in to the pile of saddle screws on the work bench. it will be replaced with the one that goes with it right after I post this.
