MOLD on speaker cones! How to clean?

[B2D]

HAY GUYS.

I just picked up a JCM900 series Marshall 1960A cab on ebay, and everything's a-ok with it except one of the speakers has mold on the cone (and a stain on the grille cloth, maybe it was next to the guy's bong :laugh2: ), and maybe its just coincidence but that one sounds a bit "scratchy" and the output of it seems to be maybe a few db lower than the other three. Keep in mind i wouldnt have noticed that unless I'd been RIGHT next to the speaker when it was on. Still works though. but I'd like to get rid of that mold if possible.

So how do I go about cleaning the speaker w/out damaging it?

 

[B2D]

Re: MOLD on speaker cones! How to clean?

Merry Xmas guys

 

[lastwinj]

Re: MOLD on speaker cones! How to clean?

pull that speaker and check to see if the voice coil is rubbing. i suspect that it is, and will need to be reconed.

 

[Gearjoneser]

Re: MOLD on speaker cones! How to clean?

I'd probably try rubbing alcohol on a washcloth.

 

[B2D]

Re: MOLD on speaker cones! How to clean?

I'll try both, thanks guys.

At any rate this gives me a good excuse to pop in two V30s for the X pattern I was planning on doing anyway.

 

[Vasshu the humanoid typhoon]

Re: MOLD on speaker cones! How to clean?

Set it on fire
Particleboards burns funny