Chistopher
malapterurus electricus tonewood instigator
Does anyone know off hand if it's possible to wire the Mustang slider switches for a humbucker to be Split/On/OOP?
Mustang Slider Wiring
- Thread starter Chistopher
- Start date
Chistopher
malapterurus electricus tonewood instigator
Welp, Alumitone's don't split 100% the same way as a normal humbucker, so that idea is out the window
Chistopher
malapterurus electricus tonewood instigator
Yeah pretty funny ones
They can also be off-on-off or on-off-on.
The issue with Alumitones is instead of splitting them by grounding one wire, as you would with traditional humbuckers, you need to ground one wire and lift another.
They can also be off-on-off or on-off-on.
The issue with Alumitones is instead of splitting them by grounding one wire, as you would with traditional humbuckers, you need to ground one wire and lift another.
Chistopher
malapterurus electricus tonewood instigator
I think I'm just going to use two way switches for coil splits. I may put the OOP setting on a push pull though just to experiment with it.
What do you guys think, should I go for the classic parallel OOP of a traditional Mustang, or series OOP so I don't have any volume loss. Even with 8-38 strings these pickups are a bit thick, but I think the coil split should be enough to change that.
What do you guys think, should I go for the classic parallel OOP of a traditional Mustang, or series OOP so I don't have any volume loss. Even with 8-38 strings these pickups are a bit thick, but I think the coil split should be enough to change that.
Chistopher
malapterurus electricus tonewood instigator
Yeah, without independent volumes the middle position in general can be a bit of a wild card.
