jonnymangia
New member
Going to put this in my Peavey Classic 30...anything I should be careful of when performing the speaker transplant? I've got an experienced electronics guy doing it but I want to be extra careful.
Jonny
Jonny
My G12H30 Just Arrived!
- Thread starter jonnymangia
- Start date
STRATDELUXER97
Stratoblaster Tone Meister
Re: My G12H30 Just Arrived!
Lay the cabinet flat upon installing the new speaker..."Gently" line up all of the holes of the speaker to the screws and make sure they all line up before you push the speaker flush to the cab...
If you are going to solder the wires to the terminal lugs of your speaker,be sure to use a heat sink between the wires to the speaker coil and the terminal so you don't overheat the wire....
jonnymangia said:
Lay the cabinet flat upon installing the new speaker..."Gently" line up all of the holes of the speaker to the screws and make sure they all line up before you push the speaker flush to the cab...
If you are going to solder the wires to the terminal lugs of your speaker,be sure to use a heat sink between the wires to the speaker coil and the terminal so you don't overheat the wire....
