need for schematic..

[6l6gc]

Happy New year, everyone!
I'm newbie here..:wave:

I purchased 3 pups..(2 Seymour Duncan Duckbuckers and 1 Gibson 57 classic)

My plan is..
Duckbuckers in 'Neck' and 'Middle' position, 57 classic in 'Bridge' position.
(My axe is fender strat)

Duckbucker is four-conductor cable...and...57 classic is single-conductor cable.

How can I make wiring?
I need some good wiring schematics please...:flush:


thanks.

 

[Artie]

Re: need for schematic..

Welcome to the forum. On the Ducks, just wire the red and white together, and tape them off, connect the green and bare together, then treat them like 2-wire pups. Green is ground, black is hot. Then follow any standard Strat wiring that you like. Here's the basic one. More on that page:

http://www.seymourduncan.com/support/schematics/3singlecoils_1vol_2tones.html

Artie

 

[6l6gc]

Re: need for schematic..

Thanks, ArtieToo!:fingersx:

all three-pups acting like "strat factory wiring" pups..right?

1. neck hum (duckbucker)
2. neck hum (duckbucker) + middle hum (duckbucker) <- is it split/hum-canceling?
3. middle hum (duckbucker)
4. middle hum (duckbucker) + bridge hum (57 classic) <- is it split/hum-canceling?
5. bridge (57 classic)


is it right?

How about 2/4 position sound?

 

[Artie]

Re: need for schematic..

all three-pups acting like "strat factory wiring" pups..right?

Exactly. All three pups will always be hum-cancelling because they're designed that way. No need to worry about how they're wired.

None of the positions will be split, but you wouldn't want that with a Duck anyway. Then you'ld only get 3 strings.

Artie

 

[6l6gc]

Re: need for schematic..

oh...thanks artie!

How about 2/4 position sound? Is Fenderish 2/4 position sound?
I can't expect..:smack: