Need help for my TELE wiring!

[matit]

Hi together!
I´m new here!
I build a SD Little59 and 2 switches in my standard tele!
So i have now a single coil, the little59, a 500k volume poti, 250k tone poti, a 3-way-switch and one switch (on/on/on) for series/split/paralell and one (on/on) for phase.
The on/on/on doesn´t work in the middle position! Should be split, but i have just a very, very low signal and i don´t now why. The rest seems to be working!
Where can i find a schematic of this combination.
Or how can i show you a schematic jpg of what i have done here in the forum!
Thanks for help!
Mark

 

[jeremy]

i dont know if ive seen a schematic for that wiring but it shouldnt be all that trickey. post a link to your jpg if you have one, if not youll have to find some one to host it for ya.

you said the middle of the on/on/on doesnt work. does everything else?

 

[Lewguitar]

Click on the Seymour Duncan Main Page at the bottem of this page...go to Support....go to Schematics....go to Humbuckers...go to series/split/parallel with phasing. It's at the bottem of the list. That might help. Lew

 

[jeremy]

ah ha, so it does exist! thanks lew

 

[matit]

Thanks for answering that quick! Cool!
Everthing else is working! Just this middle position of the on/on/on switch. Soundwise i would say series and paralell is working. So the split is not working.
The schematic Lew described is the one i used for soldering the switches. But to check everthing in need a full schematic. Cause maybe i need to change a poti or whatever???
Is 500k for volume and 250k for tone ok?
Before it was 250k Volume!
What about the resistance between tone and earth? I left the one that was in my standard tele before! Is it a resitance?!?
I try to host my picture.

 

[Lewguitar]

ah ha, so it does exist! thanks lew

You are welcome!

 

[Robert S.]

I would think that if the series and parallel options are working properly you probably wired it correctly and the middle position of that switch is bad.

Double check your wiring and then replace the switch.

 

[matit]

Re: Need help for my TELE wiring!

I triple checked the wiring. I go now and buy another switch. Hope that helps. Thanks a lot! I let you now if it works! If not, i try to show you my schematic some how. Maybe everthing is wired properly but the wrong way! First i replace the switch!
This forum is nice! And very friendly!
I´ll be back here to get tipps and tricks!
Thanks again!

 

[matit]

Re: Need help for my TELE wiring!

A bit late but here is the newest stand! The switch was broken! So i just replaced it and that´s it!!! Thanks for all your help!
Buy a Duncan pup, look a the schematics, do what they show you and it works and SOUNDS!!!! So easy! I like that!
Bye!

 

[Dave]

Re: Need help for my TELE wiring!

Wunder-uber-schoen!!!

 

[Lewguitar]

Re: Need help for my TELE wiring!

A bit late but here is the newest stand! The switch was broken! So i just replaced it and that´s it!!! Thanks for all your help!
Buy a Duncan pup, look a the schematics, do what they show you and it works and SOUNDS!!!! So easy! I like that!
Bye!

GROOVE-A-DELIC! :laugh2: Congratulations! Lew