need help wiring my invader and sh-10 into my ibanez rgt-42

[rortiz10]

Hi everyone! I need help to wire my sd's into my Ibanez rgt-42. What better place to go than this place right? Well I bought a 3 way blade switch. It looks stock has 8 outputs on it. I swapped it for the 5 way stock one. The only problem is I can't seem to find a good diagram on how to wire it. Can anyone please help me? I really want to do this myself and not take it to my local guitar shop. It works in the middle and bridge position just can't seem to get the neck going. If anyone could maybe give me a heads up on where I might find a diagram that has the complete setup from start to finish that would be great. The pups are invader bridge sh-10 neck. Everything else is pretty much stock. Just can't seem to find out how to connect everything from scratch starting at the 3 way switch and going to the pots etc.etc. Thanks for looking and for your help.

 

[GuitarDoc]

Re: need help wiring my invader and sh-10 into my ibanez rgt-42

Suggestions are in your other thread.

 

[Jocelyn]

Re: need help wiring my invader and sh-10 into my ibanez rgt-42

https://forum.seymourduncan.com/showthread.php?262864-ibanez-rgt-with-1-volume-1-tone-5-way-switch

Did it not work? I know the search function is not working, if you could not find your previous thread.

 

[rortiz10]

Re: need help wiring my invader and sh-10 into my ibanez rgt-42

I tried it but somehow the neck pickup does not work on its own. I was really looking for something on how the switch was wired to the pickups etc etc. I think that's where the problem is.

 

[Jocelyn]

Re: need help wiring my invader and sh-10 into my ibanez rgt-42

I have posted a link to that too in the previous thread .And I think I have mentioned how the stock pickups were wired too.