Need help with a Keith Richard style.

[Sheiffer]

Hi there, I need help with the wire diagram I tryed some ways and it din't worked.

The Keith Richard scheme is in the picture, what I dunno how to do is put the bidge picku spitable. Can any one help me?

Edit: I forgot to mention that ill use a filtertron on neck (no split) and a Pearly Gates (4 wires) on bridge, plus a push pull knob (CTS) for split.

 

[jeremy]

you want to split the bridge humbucker by a mini switch or ?

 

[Sheiffer]

you want to split the bridge humbucker by a mini switch or ?

I need help to split the bridge with the push-pull knob, the one I have is a 500KB CTS.

 

[beaubrummels]

Filtertron neck, Pearly Gates bridge with a split doesn't sound very Keith Richards-ish to me, but if you are only splitting the bridge, just use this diagram:

 

[Sheiffer]

Filtertron neck, Pearly Gates bridge with a split doesn't sound very Keith Richards-ish to me, but if you are only splitting the bridge, just use this diagram:

Hi Thank again, when I said Keith Richard I mean the blend instead of tone, and the switch configurations.

That's why I put the scheme on the main topic.

 

[jeremy]

the p/p pot in the diagram posted shows how to split the pup. the wiring will be the same as the top diagram you posted but with the p/p added

 

[ThreeChordWonder]

If it's a Seymour Duncan brand humbucker, bridge or neck:

• Black is the "hot" and goes to the switch
• Green is the ground and goes to ground if you're using a 3-way switch
• Bare is the shield and always goes directly to ground
• Red and white = solder the ends of both together then solder both to one common "C1" or "C2" contact on your push pull.
• Ground the contact on the push pull that connects to the push pull common when pulled.

The humbucker will coil split leaving the north (slug) coil active. This will be hum canceling with a normal Seymour Duncan "south up" single coil in P2.