Newbie Wiring Help

alboz28

New member
Hello,

Longtime Duncan pickup user...new to forum. I was wondering if someone could help finish or correct the diagram I have posted here. 4 conductor JB + SSL-4 Tapped - Thank you for your help

duncan.jpg
 
Re: Newbie Wiring Help

It appears that he hasn't learned to fish yet...since he hasn't replied.

So I guess I'll just go ahead and feed him.

alboz28,
From the bridge pup, solder the red and white wires together on the left center lug of the P/P switch. Solder a wire from the lower left lug of the switch to the back of the pot.

From the neck pup, solder the black wire to the back of the pot. Solder the white wire to the top right lug of the P/P switch. Solder the red wire to the lower right lug of the P/P. Solder a wire from the center right lug of the P/P to the left lug of the 3 way selecter switch.

When the P/P is in the down position you should get full series humbucker in the bridge and full coil of the neck pup. When the P/P is pulled up you will get split bridge pup and coil-tapped neck pup.
 
Re: Newbie Wiring Help

Thank you GuitarDoc ...I had it drawn out mostly correct , but you have shown me the errors of my way. I guess I had my fishin' pole, net and bait, but did not know where to cast my line.

Thank you again for your help.
 
Back
Top