Nate
New member
Get this..
I gutted out the old pickups from my Charvel Fusion Deluxe last week and stuck in a new passive pickup without any problems and liked the results. I decided to buy a stacked 'bucker for the neck slot (1 hum bridge, 1 single neck) and it wound up being too large for the original rout (there was no extra lip cut out on my guitar.
I just finished routing out that extra bit to make the pickup fit and wired everything back up. I wired the new pickup into the mix and replaced the spare 500k pot I was using temporarily with a brand new CTS pot. Now I'm not getting any output whatsoever. :lame: I just finished double checking all the connections to make sure nothing got knocked loose.
Any ideas you guys might have? This is a 1 vol. 3 way blade switch guitar, by the way.
Cheers!!
I gutted out the old pickups from my Charvel Fusion Deluxe last week and stuck in a new passive pickup without any problems and liked the results. I decided to buy a stacked 'bucker for the neck slot (1 hum bridge, 1 single neck) and it wound up being too large for the original rout (there was no extra lip cut out on my guitar.
I just finished routing out that extra bit to make the pickup fit and wired everything back up. I wired the new pickup into the mix and replaced the spare 500k pot I was using temporarily with a brand new CTS pot. Now I'm not getting any output whatsoever. :lame: I just finished double checking all the connections to make sure nothing got knocked loose.
Any ideas you guys might have? This is a 1 vol. 3 way blade switch guitar, by the way.
Cheers!!
