CaughtLikeFire
New member
alright guys, one last thing to unload here.
Fender American Standard loaded pickguard. B/W/B, hum-single-single configuration (Diamondback humbucker and Tex Mex single coils). S1 switching to fatten up the single coils. very few scratches - nice and shiny and darn near new.
the only flaw is a small extra hole to the left of the humbucker. it's tough to see (sorry about the slightly blurry pic) since it's right inbetween the 2 Fender factory mounting holes. I forgot it was even there until I finished typing this post.
includes one (attached) ground wire w/screw terminal that you can bolt down to the body (with shielding foil or paint of course). Or you can cut off the terminal and use it to ground your bridge.
other than the ground wire(s), the only soldering involved will be the input jack. this is an easy 2 minute job and I will include a new input jack and some wire if you need it at no extra charge
$70 shipped to the lower 48
Fender American Standard loaded pickguard. B/W/B, hum-single-single configuration (Diamondback humbucker and Tex Mex single coils). S1 switching to fatten up the single coils. very few scratches - nice and shiny and darn near new.
the only flaw is a small extra hole to the left of the humbucker. it's tough to see (sorry about the slightly blurry pic) since it's right inbetween the 2 Fender factory mounting holes. I forgot it was even there until I finished typing this post.
includes one (attached) ground wire w/screw terminal that you can bolt down to the body (with shielding foil or paint of course). Or you can cut off the terminal and use it to ground your bridge.
other than the ground wire(s), the only soldering involved will be the input jack. this is an easy 2 minute job and I will include a new input jack and some wire if you need it at no extra charge
$70 shipped to the lower 48
