Out-of-phase

[Mingsteen]

Hi all,

I have a question about combining pickups in my tele. I have installed an AlnicoII in the bridge position and to have it combine well with the stock Fender neck pickup I have reversed the wires and cut the jumper-wire from the bottom plate as the manual indicated.

Now I have a Vintage Tele (STR-1) on the way to replace the stock neck pickup. Should I also reverse the wires and cut the jumper-wire on this one to have it in phase with the AlnicoII?

Thanks!

Mingsteen

 

[vinnie1971]

Re: Out-of-phase

Desolder the jumper for the cover then attach a new lead to the cover solder point and solder the other end to ground


Sent from my iPhone using Tapatalk

 

[Mingsteen]

Re: Out-of-phase

Thanks for your response! So if I understand correctly I dont reverse the wires on the Vintage but just desolder the jumper and ground the cover?

 

[vinnie1971]

Re: Out-of-phase

I would wire it up to see if it's out of phase. If it is switch the wires then desolder the cover jumper and wire it to ground.


Sent from my iPhone using Tapatalk