P-Rail Wiring Help (Pickup and Coil Selections)

C

CJC

New member
I'm currently building a Warmoth Carved-Top Soloist with P-Rails in both the neck and bridge. I also would like to use Stellartone Tone Knobs (which unfortunately cannot be stacked or tapped) and the Graphtech Ghost modular system (yay more knobs and switches), so keeping control knobs to a minimum would be great. =)

Is there any way to use a rotary switch (like PRS) or preferably the "Megaswitch P-Model" found on stewmac.com, for selecting the various tonal possibilities within each humbucker (in/out phase, series, parallel, etc.)and then a 3-way to then activate which position will be turned on? I would like to be able to choose between coil, humbucker, and P-90 (an additional switch would be okay, I guess.)

I was currently planning to use a concentric volume pot for controlling each pickup independently, two tonestylers for each pickup and then another concentric volume for the Graphtech Modular system needs. Any coil-tapping or whatnot would be DPDT switches. If there is a better way, or any helpful advice, it would be much appreciated.
 
Re: P-Rail Wiring Help (Pickup and Coil Selections)

This is perfect. =) Now where can I buy it? lol
 
Re: P-Rail Wiring Help (Pickup and Coil Selections)

You can get your pre-order in from any of our dealers. They'll probably start shipping in a few weeks. There are some chain stores ordering, too, so that means if you can get a pre-order in to one of the independents, you'll probably beat everyone since the chains will get some, and have to pass them through their distribution center, etc. If you're not in a hurry, then wait a about 45 days and everyone should have them.
 
You must log in or register to reply here.
Back
Top