Partial split with Schaller Megaswitch M

[Linoleum]

Hi! Noobie here, I need some help please for a partial coil split.

I'm setting up a Seymour Duncan HH with a Schaller Megaswitch M, one volume, one tone.
I'm using the Schaller diagram for splitting coils in positions 2 & 4 (outer coils in active mode).

If I want to do a partial split, where do I connect the resistors?
Between ground and which pin?

I spent days trying to figure it out online and I just cannot do it.

Thank you so much!!

 

[Artie]

You would put the resistor between the red wire and the switch. (Red arrows.) Not ground.

However, did you already buy the Megaswitch? I really don't like how they did the split. A Superswitch would be much better. Notice how I redrew the #2 position. #4 would be the same. The Megaswitch leaves the unused coil "hanging" on the hot side of the circuit, like a big ole noise antenna. Some people have had no problem with this, but it's something to be aware of.

 

[Linoleum]

Thank you so much for the quick answer!

Yeah, I already have the megaswitch installed.
That’s the way I tried it when I first installed it, but what it did - it was partially split in both positions 1 and 2. And in 3 and 4 respectively. Basically the humbuckers were also partially split in positions 1 and 4.