Re: peavey amp question
i think its one of the older ones, but i am not sure how old because the metal serial number plate on the back is gone,(the plate is there, just not the overlay with the sn info) it is made in u.s.a. and has the old style(think 70's and 80's peavey) type covering, the really hard rubery textured stuff. it has the old style black face plate and logo with all the push/pull knobs on the pregain and high eq knob. on the gain section it has 3 knobs, pre-gain saturation and post gain, with the pre gain having a push/ pull for thick and on the eq side it has low mid high, with the high being push/pull for bright. then it has a reverb knob. it is rated at 35 watts and a jack for the footswitch in the back(i didnt get a footswitch with it) it has an unlabeled (label had been peeled off) 12 inch speaker with a huge magnet (almost like an old e/v speaker magnet, but not quite) the rest of the input jacks are on the front. i am sort of curious about the amp because all of the backstage plus amps i have seen were 10 inch speakers and considerably smaller than this one. at first i thought maybe someone had built a new cab, but on the inside of the amp it has factory markings from peavey. either way, it has awesome tone for a small peavey and for $45 bucks, i couldn't pass it up. i was just wondering mostly what the "pre out/pwr in" jack was for.
