Pedals into Fender Blues Junior –> horrible sound

Re: Pedals into Fender Blues Junior –> horrible sound

Re: Pedals into Fender Blues Junior –> horrible sound

I have always been curious to read or hear reports of how this separate head and cab conversion kit sounds. If you check out the picks you will see that the amp chassis is reoriented so the heat from the tubes no longer rises up into the circuitry like the stocker does. That's always been a source of frustration for amp techs as amps that get a significant amount of use can start to cook the traces on the PCBs. I used to own an amp from a different company that was built that same way and you could see the discolouration of the board and it created lots of intermittent issues for me. It was rather frustrating. I eventually bit the bullet had the board properly repaired at a hefty expense and then I sold it right after, while I still could get something out of it.

To the OP, I apologize again.
We've kind of derailed your thread.
So that's why the better amps have the tubes standing on top of the board vs hanging under them.
Makes sense.

Sent from my Alcatel_5044C using Tapatalk
 
Re: Pedals into Fender Blues Junior –> horrible sound

Re: Pedals into Fender Blues Junior –> horrible sound

So that's why the better amps have the tubes standing on top of the board vs hanging under them.
Makes sense.
Older amp designs usually had the tube sockets mounted to the steel chassis rather than mounted directly to the turret board. Newer amps often see the sockets mounted directly to the PCB which is problematic in a gigging amplifier. Not as detrimental in a home practice amp that does not see the same amount of power-on time. In no way is the Blues Junior singled out in this respect. It is just one of a great many. Something to look for, perhaps if longevity is a concern.
 
Last edited:
Pedals into Fender Blues Junior –> horrible sound

Pedals into Fender Blues Junior –> horrible sound

I really love the Eminence Texas Heat speaker for any Fender amp design.

Eminence says it is 2/3 American, which gives it a great clean, and 1/3 British, so it takes distortion well!

Another point is that for any amplifier that is set for very pristine clean, distortion sounds shriller than it does coming out of a slightly dirty amp or one with the mids set higher. Most great clean sounds have the mids cut back a bit.


Sent from my iPhone using Tapatalk
 
Re: Pedals into Fender Blues Junior –> horrible sound

Re: Pedals into Fender Blues Junior –> horrible sound

Glad I came across this thread, I feel the same about my Blues Junior. I think I'll give the Eminence Cannabis Rex speaker a try.
 
Last edited:
Re: Pedals into Fender Blues Junior –> horrible sound

Re: Pedals into Fender Blues Junior –> horrible sound

The blues jr was my first tube amp (way back in '97/'98) I think it was the first revision.

I could never get it to sound good with anything but a tube screamer. And even then I had the same issues as the op.

I even ran it thru different cabinets and speakers.

I can believe blues Jr's cost 600 bucks or more for the ltd editions!
My laney lionheart l5 is easily twice the amp. For not much more, and comes with a celestino anniversary speaker stock.
 
Re: Pedals into Fender Blues Junior –> horrible sound

Re: Pedals into Fender Blues Junior –> horrible sound

The first thing to do is clip out the hardwired 100 pF bright cap.
 
Re: Pedals into Fender Blues Junior –> horrible sound

Re: Pedals into Fender Blues Junior –> horrible sound

Cannibus Rex fixed mine.
 
Re: Pedals into Fender Blues Junior –> horrible sound

Re: Pedals into Fender Blues Junior –> horrible sound

Yeah, I venture to say that amp and speaker aren't voiced well for a Big Muff. That's sort of a pseudo vintage tribute amp voiced for traditional 50s blues with 50s drive
 
Back
Top