Pickup Id: Texas hots?
- Thread starter matt117
- Start date
beaubrummels
Well-known member
Re: Pickup Id: Texas hots?
6 seems a little low for Texas Hots but maybe within tolerance. Looks like someone marked the neck with an M, the current neck was originally the middle in the set?
6 seems a little low for Texas Hots but maybe within tolerance. Looks like someone marked the neck with an M, the current neck was originally the middle in the set?
Re: Pickup Id: Texas hots?
I’m not sure! Just how it came and it plays all in phase with each other. Should I be changing them around? The current middle had a higher ohm reading. I actually took the Texas special bridge pup out it came with and put the stock mim ceramic bridge in. It keeps up better.
Before this I was using an ssl1 I had laying around in the neck with the stock mim middle and bridge. So far I think I enjoyed the ssl-1 a bit more then the Texas hots. But ideally I’d like something half ways between the Texas hot and ssl-1. The ssl-1 is a hair too loose on the top end for me. And the Texas hot might be too mellow/warm.
I’m not sure! Just how it came and it plays all in phase with each other. Should I be changing them around? The current middle had a higher ohm reading. I actually took the Texas special bridge pup out it came with and put the stock mim ceramic bridge in. It keeps up better.
Before this I was using an ssl1 I had laying around in the neck with the stock mim middle and bridge. So far I think I enjoyed the ssl-1 a bit more then the Texas hots. But ideally I’d like something half ways between the Texas hot and ssl-1. The ssl-1 is a hair too loose on the top end for me. And the Texas hot might be too mellow/warm.