I've wired my new Duncan pickups according to the wiring diagram I got with my new Aguilar OBP-1. I wired the blend pot like it showed. The problem is that when the knob is centered at the detent, I get no output. I would say that this is a phase problem, but the two pickups are different models, and there is absolutely no output. When I turn the knob to either direction, the correct pickup gets louder until the pot has been fully turned to either direction.
More info: Here's how I wired the pickups (as if looking at the back of the pot, with the terminals at the top): The top row is for the bridge pickup. The left terminal is the output and it's jumpered to the lower right terminal for the output of the neck pickup. The top right is jumpered to the lower left for ground. The center on each row is the input: top for the bridge and bottom for the neck. Before wiring the pot, I tested for continuity. When the knob was turned as it would be for neck the lower middle and lower right terminals had continuity. When the knob was turned the other extreme, the top middle and top left terminals had continuity.
Please Help!
Thanks, Footer.
More info: Here's how I wired the pickups (as if looking at the back of the pot, with the terminals at the top): The top row is for the bridge pickup. The left terminal is the output and it's jumpered to the lower right terminal for the output of the neck pickup. The top right is jumpered to the lower left for ground. The center on each row is the input: top for the bridge and bottom for the neck. Before wiring the pot, I tested for continuity. When the knob was turned as it would be for neck the lower middle and lower right terminals had continuity. When the knob was turned the other extreme, the top middle and top left terminals had continuity.
Please Help!
Thanks, Footer.
