Re: Possible to swap conductors?
Ok, I'll confess. I'm trying to do a quick, dirty, and ugly fix to an extremely annoying situation. I pulled the yucky Duncan Design 'buckers out of a guitar, and dropped in my nifty Distortion set. But there was one problem... The lead on the Distortion set isn't long enough, and I didn't check before beginning the whole installation process.
I don't want to put the Duncan Design set back in, and I am impatient to get this guitar rocking again. So I'm thinking of clipping the lead of the Duncan Design set and the short lead of the Distortion set. Then I would bridge the long 4-conductor Design lead to the Distortion pups (which were already set up for 4-conductor.)
Assuming I match the leads up correctly, this should work, right? ha ha ha. in theory...
I could order new 4-conductor wire, but I don't want to wait, and I don't plan on using these Duncan Design pups again. Unlike some other Design sets I've had, these sound weak, lifeless.
But this old Distortion set - that's another story! Killer!
Thanks very much guys, for taking the time to chime in.
Cheers