First time installing new pick guard, new duncan disortion trembucker (split in the #4 position), new ssl-3 hot for strat neck, ssl-3 RW/RP hot for strat middle, new volume and tone pots (250k) Used seymour wiring diagram for split in the #4 position. Tested with no srings, in the single coil positions (#4-#1) there is tons of hum, also the neck pup seams to lack output. Any help would be greatly appreciated. Hello fellow members. Im the new kid on the block!
Problem Installing DD IN Bridge (STRAT)
- Thread starter STRATZ
- Start date
T
TheArchitect
Guest
Re: Problem Installing DD IN Bridge (STRAT)
I would expect the singles by themselves to hum. Thats normal. However my gut feeling is that you have a problem somewhere on the earth side of the circuit. Review your work with the schematic one more time.
I would expect the singles by themselves to hum. Thats normal. However my gut feeling is that you have a problem somewhere on the earth side of the circuit. Review your work with the schematic one more time.
JB_From_Hell
Jomo's Nimions
Re: Problem Installing DD IN Bridge (STRAT)
Welcome to the forum
I may be mistaken, but in a H-S-S setup, is it the neck that neck that should be rw/rp?
Welcome to the forum
I may be mistaken, but in a H-S-S setup, is it the neck that neck that should be rw/rp?
Re: Problem Installing DD IN Bridge (STRAT)
You are the man Architect, after reviewing my conections I noticed that I had ran the grounds of the body, to the middle tone pot. After re-soldering it to its proper location (volume pot) and installing the strings Im in duncan town. This is a project strat my son and I are constructing for him. I have been ripping heads off with my 75 srtat for over 20 years. Thank You Very Much!TheArchitect said:
Re: Problem Installing DD IN Bridge (STRAT)
Thank you for the input JB. If I didn't solve the problem I would have used your suggestion next. I ended up leaving the RW/RP pup in the middle position. That ended up not being the problem in my particular case. I'm new here on the sight, but I will be hanging out often, maybe I can help out another member in the future. Thanks again.
Thank you for the input JB. If I didn't solve the problem I would have used your suggestion next. I ended up leaving the RW/RP pup in the middle position. That ended up not being the problem in my particular case. I'm new here on the sight, but I will be hanging out often, maybe I can help out another member in the future. Thanks again.
T
TheArchitect
Guest
Re: Problem Installing DD IN Bridge (STRAT)
Glad it worked for ya! And welcome by the way.......
STRATZ said:
Glad it worked for ya! And welcome by the way.......
