Push pull in STC 3M4 preamp

[tres9774]

Hi, would it be possible to wire the push pull on my STC 3m4 preamp to series-parallel instead of the slap contour? Thanks

 

[tres9774]

No one?

 

[jeremy]

im guessing yes, but i havent looked at the preamp in a while. the slap contour is an active circuit, series/parallel is passive, but you should be able to rewire the dp/dt switch for that without issue

 

[tres9774]

Ok thanks, could you tell me how to rewire then ?

 

[jeremy]

WD_Pushpull_minitoggle_3.pdf

 

[tres9774]

Ok, so its not possible to use the push-pull, present in the circuit?

 

[tres9774]

this

 

[Chistopher]

I would say you should consult the manufacturer, but it looks like you can omit all the wires coming off the slap switch and replace them with a series parallel.

 

[tres9774]

Ok, thanks

 

[jeremy]

i dont see any reason you could not remove the slap circuit from the switch and wire the series/parallel as shown in the diagram