Push-pull vol + 3-way toggle switch

[Metalblaze]

I'm thinking a wiring case involving 1 humbucker and 2 single coils as an HSS set using a push-pull vol pot and a 3 way blade switch only.

The options would be these:

1. Bridge HB
2. Middle SC
3. Neck SC

and when push-pull pot is engaged:

1. Bridge HB + Neck SC
2. Middle SC + Neck SC
3. Neck SC

Meaning that the switch will work as it is in both cases but the push-pull pot will add the neck SC into play. I guess it can be?

I think it can be done but I've never messed around with push-pull pots so I'd like the opinion of the guys that had, if possible.

 

[Metalblaze]

Re: Push-pull vol + 3-way toggle switch

kicking this to the top for a 2nd chance

 

[drdave]

Re: Push-pull vol + 3-way toggle switch

I'm assuming that your 3-way blade is like a 5-way without the "in between" positions? Then you should be able to start from this http://www.seymourduncan.com/suppor...tics.php?schematic=1hum_2sing_1vol_1tone_5way and have the push-pull connected to make contact between the neck white wire and the black wire that goes from the switch to the vol pot.

Does that help?

 

[jeremy]

Re: Push-pull vol + 3-way toggle switch

i actually just wired something like that up.

1-surfer
2-lil 59
3-patb3

pull up and it turns the middle pup on no matter where the switch is, a second push/pull for splitting the coils on the two buckers

 

[Metalblaze]

Re: Push-pull vol + 3-way toggle switch

Ah thanks guys! That's what I was initially thinking but wasn't sure as I've never used push-pull pots.