Question about powering my pedalboard...

[wickenspoet]

I've got a Dunlop Brick Power Supply.

All 7 of the 9-volt plugs are being used from the Brick to power my pedals, including my Boss NS-2 (which also has the ability to power pedals with a daisy chain)

All my pedals are have standard 9-volt adapter jacks. Right now, the Brick powers my Wah, 2 Distortions, Noise Suppressor, Tremolo, Delay, and Clean Boost Pedal. The Brick's 7 slots are used up... so I'd like to hook a daisy chain to from the Noise Suppressor to power my Tuner. (instead of buying the 8 input BBE Supa-Charger Power Supply, because that's a lot of money for an extra power jack)

Will it hurt anything or cause any hum if I use the Boss NS-2 to power one or two more pedals with a daisy chain... because the Boss NS-2 is getting its power from the Brick?

Oh, and do they make a single daisy chain that just has 2 barrel jacks, one on each end? Because I don't need the extra ones and I'm a neat freak.

 

[skyydogg01]

Re: Question about powering my pedalboard...

as long as your brick puts out about 200 mA per jack, you should be fine powering both pedals with one jack. as far as just a cable with 2 plugs, good luck. I haven't seen one yet. You could always make your own. Go to radio shack and pick up 2 barrel plugs (I think size N) and some wire and go to town.

 

[wickenspoet]

Re: Question about powering my pedalboard...

Yeah, I think it should be okay, then. We'll see. Thanks.