RMC 3 Wah questions

D

drjones

New member
Hi all,

I just scored an RMC3 wah on ebay and have a couple of questions. I'm not after how to set it to particular sounds. There is a chart that came with it with suggested settings. Now, if it says to adjust an internal trim pot to 5, does that mean to 5 o clock? or are the trim pots 'numbered' like the knobs on a guitar amp? (1 would be where the pot is twisted all the way anti clock wise?). and which part of the pot am I using to match to the value? Is it the screw driver slot or is there a mark on it somewhere.

Secondly can I use the same power supply as I was using to power a Crybaby wah? I will put this on my board once I figure out the settings, and it will be powered by the 9v output of the dunlop brick that was powering the crybaby.

Thanks for reading.
 
Re: RMC 3 Wah questions

You CAN NOT power an RMC wah with a DC Brick.

It will work but it will be a noise trap and it will void the warranty.

As for the trim pot no clue...email Geoffry and ask him, he's a great guy and will get back to you ASAP.
 
Re: RMC 3 Wah questions

Thanks for that, I hadn't plugged it in yet. There is a big piece of velcro over the power supply requirements. Cheers.
 
You must log in or register to reply here.
Back
Top