Series Parallel Diagram

[robrhy]

Looking for a diagram for "2 Humbuckers,1 Volume,1 Tone,2 Push Pulls,3 Way Switch,Series Parallel".Had a look at SD wiring diagrams but all i can see is "1 Humbucker, 1 Volume, 1 Tone, Series Parallel" not saying there is not one,just i can't see it :blindfold

 

[korus]

Re: Series Parallel Diagram

No there isn’t the one youy need, but you can mix 2 of them that exist there in order to have what you need.

a. http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=1h_1v_1t_sp here you have push-pull part
b. http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=2h_1v_1t_3w_2pp here you have pots part

I guess you will use vol pot’s push/pull to switch neck PU ser/par, and tone pot’s push/pull to switch bridge PU ser/par.
If so, it goes like this :

1. connect neck PU’s wire’s to push/pull part of vol pot as on wiring a.
2. connect bridge PU’s wire’s to push/pull part of tone pot as on wiring a.
3. now instead of connecting neck PU’s black wire with input of vol pot (like on a.), use a separate wire/lead to connect push/pull where black wire is with 3way selector switch’s outter lug (like on b. where black is connected), then connect bridge PU’s black wire from push/pull on tone pot with a new separate lead/wire with the other outter lug on 3way selector switch.
4. connect mid lug on 3way using new/separate wire with input of vol pot like seen on wiring b.
5. the rest of connections on pots is the same as on b.
6. done

HTH. If anything is unclear, I’ll try clarify. Good luck.