chill
New member
I was thinking about strat wiring options, and with a DPDT push pull pot, I came up with this: connect the "ground" leads of the neck and bridge pickups to the middle lug of one pole; lower lug of that pole to ground, upper lug of that pole to the middle pickup's hot lead; jumper across the two upper poles; middle lug of the other pole to the top of the blend pot, with it's wiper going to ground, which blends the middle pickup in and out only in series mode. The outputs are connected as normal. With the blend pot replacing one tone pot, use the tone side of the switch to change tone caps. Any thoughts?
