SEYMOUR DUNCAN AHB-1 ACTIVE PICKUPS WIRING (NEED HELP)

[haris1687]

HEY GUYS,

I JUST GOT MY NEW SET OF ACTIVE AHB-1 HUMBUCKERS AND I DOWNLOAD WIRING DIAGRAM FOR 1 TONE 1 VOLUME AND 3 PICKUP SELECTOR SWITCH. I FOUND IN THE DIAGRAM THAT THERE ARE 3 WIRES COMING FROM PICKUP ( ONE RED ONE WHITE AND ONE THEY HAVE MENTIONED BARE).

WHEREAS IN ACTUAL SET OF WIRES THE RED WIRE OF PICKUP IS SEPERATE AND WHITE AND BARE ARE COMING OUT OF ONE INSULATION.( AS SHOWN IN PIC ATTACHED)

MY QUESTION IS THAT , DO I HAVE TO REMOVE THE BLACK INSULATION ALL THE WAY TO GET THE BARE WIRE LONG ENOUGH TO CONNECT IT TO GROUND SOLDER POINT???? AND WHITE WITH SELECTOR SWITCH? AND IWILL LEAVE THE BARE WIRE BARE I MEAN WITHOUT ANY INSULATION OR TAPE. ??

WAITING FOR REPLY SO THAT I CAN INITIATE MY PICKUP REPLACEMENT PROJECT. THANKYOU

 

[sosomething]

Re: SEYMOUR DUNCAN AHB-1 ACTIVE PICKUPS WIRING (NEED HELP)

Hi,

Yes, you will need to remove some of the black tubing to spread out the ground (bare) from the other wire so they can reach where they need to go inside your guitar. No additional shielding is needed on the bare wire.

 

[Funkfingers]

Re: SEYMOUR DUNCAN AHB-1 ACTIVE PICKUPS WIRING (NEED HELP)

WAITING FOR REPLY SO THAT I CAN INITIATE MY PICKUP REPLACEMENT PROJECT.

Too deafened to answer.