spring reverb repair/ mod

J

joeydude

New member
ok so my spring reverb is ****ed. 2 of the springs are only attached at one end, and one is completely detached. things i should know about repairing it??

also

would it be possible to turn this into a pedel, or a rack mount sorta type thing that i could run through another amps fx loop??


i can post pics of the damaged reverb if neccesarry.

thanks
 
Re: spring reverb repair/ mod

If the springs are disconnected from the transducers, it's toast. I have repaired the little hangers that go into the transducers, but they never quite sound the same. Just get a new one---AES has a pretty wide variety, and last I remember, they ran about 25 bucks, 3-spring might be a bit more (?). As far as turning it into a standalone reverb, you need a power supply and a few other odds and ends. It will cost way more than it's worth and requires a bit of skill...just toss the old one and don't look back.
 
Re: spring reverb repair/ mod

dang!

guesse its time for a holy grail or something...

AES?? they got a website?
 
Last edited:
Re: spring reverb repair/ mod

You can get a replacement tank from Mojo.....maybe $30.00 or so.

Take the code off of the old one, order the direct replacement & install it.

Not too tough at all.

I replaced one in a Fender Reverb Tank & it was pretty much a piece of cake :bigok:
 
You must log in or register to reply here.
Back
Top