I have a Suhr HSS pre-made harness from the 920D Custom Shop. Going to use a Custom 5 and a neck and middle SSL1. The middle tone pot which I assume is assigned to the humbucker, has a .047 cap on it. I am not very fond of that cap and would prefer a .022 cap. If I swap the .047 for the .022, will it affect anything else in the wiring scheme or just the middle tone pot? I understand how the wiring scheme works in general but not sure the exact cause and effect of the particular cap on that tone pot.
Suhr HSS wiring question
- Thread starter JoePeeper
- Start date
Re: Suhr HSS wiring question
Well I posted this prematurely. After some more research I stumbled across the information I needed. I was wrong about pot assignment. The .047 cap is on the tone pot assigned to the single coils. Its the tone knob directly next to the volume pot. I will be swapping out that tone cap...just not a big fan of the .047. I find it too dark.
Well I posted this prematurely. After some more research I stumbled across the information I needed. I was wrong about pot assignment. The .047 cap is on the tone pot assigned to the single coils. Its the tone knob directly next to the volume pot. I will be swapping out that tone cap...just not a big fan of the .047. I find it too dark.
Similar threads
